A couple weeks ago, we reported that Hummer owners had to put their vehicles in gear to get water out of their vehicles because the pump was a little too heavy to lift.
In a nutshell, the pump’s hydraulic arms were bent in the front and the rear.
Now, Hummer owner Andrew “Andy” Brown has a solution: install a hydraulic arm to lift the pump.
And he’s hoping to sell it to someone for $400,000.
As we reported in our story about the new pump, the new system will be much simpler than the one that was installed on the old Hummer, and it will allow for the water to be removed from the vehicles at the source of the pump, rather than at the pump itself.
Brown is hoping that by adding the new arm, the Hummer can be a little easier to lift when things are at their worst.
He says that the arms are a little wider than the ones on the previous Hummer and the new one has a more robust, longer-lasting, more robust bearing.
The first thing to notice about the arm is that it’s a bit more complicated to install than the previous one.
First, the arm needs to be connected to the front of the Humvee.
Then, the arms need to be bent into the front, then the rear of the vehicle, and finally the front end needs to come up on the back.
This makes it a little more difficult to install on the front.
Then, Brown needs to put the new arms on the rear and the front on the car.
It’s important that the arm stays in place on the vehicle and that the front ends don’t move when the pump is in gear.
To accomplish this, Brown installed a couple of new mounting hardware that help keep the arms straight and that can hold the arms at a 90-degree angle.
Then he installed two new bearings that can help keep that arm in place and that also keep it from moving.
The end result is that when the Hummers in operation are in gear, the old pump can be lifted a little bit easier.
This new arm will also be able to lift it a lot easier.
Now Brown is trying to sell the arm, which he plans to give away to a local dealership.
That’s why we’re here with NBC News to tell you about it.
Andy Brown says he had a couple problems getting the arm to work on the Hummels before, but this one was even worse.
The first problem was that the Hummons used a new, more powerful version of the hydraulic pump.
But it wasn’t long before the pump became stuck in a gear when they switched from the older pump to the new version.
This meant that the old, stronger pump could no longer lift the Humms and they had to resort to putting the vehicle into gear.
Then when the gear was out, the newer, less powerful pump became too heavy.
The Humms had to go into gear again and the older version of their hydraulic pump broke.
Andy says he has a new hydraulic pump that he’s finally had the arm install.
The other problem was the fact that the new, stronger, and more powerful pump would need to hold the water out for too long to be used.
Andy said that it takes a little longer to get the water from the source to the pump and it takes more time to remove the water.
And then there was a small problem that he says the new hydraulic arm solved.
He’s still trying to figure out how to get it to work.
If Andy sells this arm to someone, he says that it would probably be a pretty good deal because the current Hummers cost around $2,500 each.
Andy’s hoping that someone could buy it for $600,000, which would be about half of what it costs to install the old one.